C O N F I G U R A T I O N F I L E S
C H A P T E R 5
69
ECOTEL 3G 16.1. Revised: 1 March 2011.
StunServerPollInterval=<sec>
Interval (in seconds) for the stun request at each port (default 600).
Radius=<mode>
On
(default) activates the Radius service. If you change
Off
to
On
, you must restart the system.
RadiusAuthPort=<num>
Port used for Radius authentication (default 1812).
RadiusAcctPort=<num>
Port used for Radius accounting (default 1813).
NameServer=<ip addr>
IP-address configuration for the DNS server. Enter your network or ISP’s DNS server. If you don’t know it, you
can also enter another DNS server. If you have more than one address, enter this parameter up to three times
on different lines.
Timezone=<continent/city>
Defines the time difference between the ECOTEL’s time zone and time zone 0 (Greenwich Mean Time). Enter
the continent and a large city (usually the capital) in the time zone.
NtpServer=<ip addr>
Sets the IP address at which the ECOTEL’s SNTP server queries the standard time. The query occurs every four
hours.
NOTE: If your system is not attached to an NTP server, you can enter the following configuration
to query the time on an attached PBX via a TE port:
Subscriber=...TIME
MoipPort=<port>
Defines the GATE Manager access port (default
4445
).
FtpdPort=<port>
Defines the FTP access port (default 21).
TelnetdPort=<port>
Defines the TELNET access port (default 23).
TftpdPort=<port>
Defines the TFTP access port (default 69).
Ftpd=<mode>
Activates (
on
) or deactivates (
off
) FTP access. Default
on
.
Telnetd=<mode>
Activates (
on
) or deactivates (
off
) TELNET access. Default
on
.
Table 5.18
pabx.cfg: IP Configuration System Parameters
(continued)
System Parameters
