M O B I L E C O N F I G U R A T I O N O P T I O N S
C H A P T E R 9
167
ECOTEL 3G 16.1. Revised: 2011.
converted as:
Be sure to make the following entry in the
pabx.cfg
configuration file to configure this conversion:
The ECOTEL system converts
national
into one zero and
international
into two zeros.
The following configuration exemplifies this conversion as it might occur in Germany:
This example shows how the customer’s network provides the prefix
intern49+1555+destination
number
for one mobile network, and
intern49+1556
for the other. The configuration entries see to it that
0destination number
is converted to
destination number
and
0destination number
is converted to
destination number
. The calls to the
carrier with prefix 01555 are routed to ports with the number 20 and calls to the carrier with prefix 01556 are
routed to the ports with the number 21.
9 . 3 . 2 U S I N G T H E L A I N A S T H E M O B I L E P O R T A D D R E S S
Use the LAIN as controller with the
CHADDR
parameter to prevent logging onto the wrong SIM card. This will en-
sure that routing is network specific. The following example is based on the German country code. One carrier’s
LAIN is
26212
and the other carrier’s LAIN is
26213
:
pabx.cfg
<port><mobile network access number><destination number>
MapAll<nat./int.>prefix[incoming]>=<port><mobile network access number>
...
MapAll00491555=2001555
MapAll00491556=2101556
...
...
Controller04=20 UMTS
Controller05=20 UMTS
Controller06=20 UMTS
Controller07=20 UMTS
...
Subscriber04=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] CHADDR ALARM
Subscriber05=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] CHADDR ALARM
Subscriber06=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] CHADDR ALARM
Subscriber07=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] CHADDR ALARM
...
If you remove the keyword
CHADDR
from the
pabx.cfg
, you must restart the system.
Controllers belonging to the same trunk group must have the same address. You must
delete all routing entries based on port addresses when using the LAIN as controller.
i
i
