M O B I L E C O N F I G U R A T I O N O P T I O N S
C H A P T E R 9
170
ECOTEL 3G 16.1. Revised: 2011.
Setting Start Units
The following example shows how you can use the keyword ChargeUnitFirst=<seconds> to configure a starting
unit for LIMIT. The following entries are used for SIM card rates where the first defined number of seconds are
always charged (e.g. the first minute). After this initial number of seconds has passed, the subsequent charges will
be calculated in intervals defined by
ChargeUnitGenerate
(e.g. every 10 seconds):
Information about the active SIM cards can be found in GATE Manager and
Port Status
.
To remove limits from the configuration, follow these steps:
Enter
LIMIT[-]
.
Activate the configuration.
Delete the entry
LIMIT[-]
.
Activate the configuration again.
9 . 6 . 1 C O U N T S T A T U S I N F O R M A T I O N
To find information about the current counts and limits for each mobile channel, click
Statistics
in the
GATE Manager.
For mobile ports:
Count A-F
For each mobile channel. Bear in mind that only one SIM card per channel is possible (
Count
A
). Counts are the time slices (from 0 to the limit value) for the individual SIM cards. When a SIM’s set
time limit is reached, the channel will disconnect and the SIM will be blocked.
Click
Reset/Set
Counters in the
Statistics
context menu in GATE Manager to reset the counters (default
value is 0). You can also configure the counters to reset automatically (see Chapter 11.1 on page 195
...
ChargeUnitFirst=60
ChargeUnitGenerate=10
...
Subscriber00=TRANSPARENT ROUTER UMTS[0000,00000,+00000,1,1,1,SIM4] LIMIT[6061,-] ALARM NEXT...
...
If
LIMIT
is configured, bear in mind that SIM 1 must be configured in the
pabx.cfg
for the corresponding mobile port.
i
i
