M O B I L E C O N F I G U R A T I O N O P T I O N S
C H A P T E R 9
173
ECOTEL 3G 16.1. Revised: 2011.
The only difference is in the active SIM card. Activate the configuration after the required files have been copied
onto the system.
Bear in mind, that you must also make the appropriate entries in the corresponding
route.cfg
sections. For
more information, please refer to Chapter 5.3 on page 74
.
If the parameter WAITBREJ appears in the Subscriber line, the mobile controller will not be used after B-side release
(mobile network) for a random amount of time between 1 and 30 seconds (default). This can happen during the
call setup phase if the mobile network signaling channel is full or the BTS has no channels left. To set another ran-
dom interval, enter the lower and upper values between 0 and 255 in square brackets after the parameter.
Example:
9 . 1 0 M O B I L E - U S E R P B X C A L L B A C K
When the ECOTEL is implemented in a corporate network and connected to a PBX or between a PBX and the out-
side line, the following configuration entry activates a feature, that uses a mobile caller’s OAD to connect with the
last PBX extension the caller unsuccessfully dialed:
DialBack=<hours>
The callback list is active for the number of hours entered.
DialBackMinutes=<minutes>
The callback is active for the number of minutes entered. After that time, the callback record is deleted in the sys-
tem.
Example:
In the following example, the callback list is active for the previous five hours. The German coun-
try code is used for the LAINs. All calls with the prefixes 1111 and 2222 are terminated through
the carrier with the LAIN 26212. Calls with the prefix 3333 are terminated through the carrier
[System]
...
Subscriber04=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] ALARM
Subscriber05=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] ALARM
Subscriber06=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] ALARM
Subscriber07=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] ALARM
...
[Night1]
...
Subscriber04=TRANSPARENT ROUTER UMTS[0000,00000,+49555,-,1,1,SIM4] ALARM
Subscriber05=TRANSPARENT ROUTER UMTS[0000,00000,+49555,-,1,1,SIM4] ALARM
Subscriber06=TRANSPARENT ROUTER UMTS[0000,00000,+49555,-,1,1,SIM4] ALARM
Subscriber07=TRANSPARENT ROUTER UMTS[0000,00000,+49555,-,1,1,SIM4] ALARM
...
Subscriber04=TRANSPARENT ROUTER UMTS[0000,00000,+00000,1,1,1,SIM4] CHADDR WAIT[20,40] WAITBREJ[10,20] ALARM
Callback is not possible for VoIP calls.
i
i
