Teledyne T3LCR1002, User Manual, Page: 125 / 147

T3LCR Series User Manual
123
The TRIGger subsystem command group is used to enable a measurement or
a sweep measurement, and to set the trigger mode.
The TRIGger:IMMediate command causes the trigger to execute a
measurement or a sweep measurement, regardless of the trigger state.
Command
Syntax
TRIGger[:IMMediate]
Example SEND> TRIG<NL>
Note This command can be ONLY used in BUS trigger mode.
The TRIGger:SOURce command sets the trigger mode.
Command
Syntax
TRIGger:SOURce {INT,MAN,EXT,BUS}
Parameter Where, {INT,MAN,EXT,BUS} is
INT Internal Trigger Mode
MAN Manual Trigger Mode
EXT External Trigger Mode
BUS BUS Trigger Mode
Example SEND> TRIG:SOUR BUS<NL>
Query Syntax TRIGger:SOURce?
Query Response {INT,MAN,EXT,BUS}
Example
SEND> TRIG:SOUR?<NL>
RET> INT<NL>
The TRIGger:DELAY command sets the trigger delay time.
Command
Syntax
TRIGger:DELAY {<float>,min,max}
TRIGger:DLY {<float>,min,max}
TRIGger
[:IMMediate]
:SOURce {INT,MAN,EXT,BUS}
:DELAY(DLY)
<float value>,min,max
www. .com
information@itm.com 1.800.561.8187