Teledyne T3LCR1002, User Manual, Page: 119 / 147

T3LCR Series User Manual
117
The LIST or SWEEP Subsystem command group sets the List Sweep
measurement function, including the sweep point setting and limit values for
the limit function.
The LIST:PARAmeter command sets the list sweep parameter.
Command
Syntax
LIST:PARAmeter {FREQ,VOLT,CURR}
Parameter Where, {FREQ,LEVEL} is:
FREQ Sets the sweep parameter to frequency
VOLT Sets the sweep parameter to voltage level
CURR Sets the sweep parameter to current level
Example SEND> LIST:PARA VOLT<NL>
Query Syntax LIST:PARAmeter?
Query Response {FREQ,VOLT,CURR}
Example
SEND> LIST:PARA?<NL>
RET> FREQ<NL>
The LIST:STAT command turns on/off the specified sweep point.
Command
Syntax
LIST:STAT <n>,{ON,OFF,1,0}
Parameter Where,<n> is:
n
NR1(1 to 10): List sweep point
ON or 1 Set this point to ON
OFF or 0 Set this point to OFF
Example SEND> LIST:STAT 1,ON<NL>
Query Syntax LIST:STAT? <n>
LIST
:PARAmeter
:STAT
{FREQ,VOLT,CURR}
<n>,{ON,OFF}
:BAND
<n>,<value>,{A,B,OFF},<low>,<high>
www. .com
information@itm.com 1.800.561.8187