Teledyne Princeton Instruments PI-MTE, System Manual

Page: 75 / 118

Chapter 7 Troubleshooting 75
4. Save the edited file.
The next time WinView is launched, the new name will be displayed on the Hardware
Setup dialog as illustrated in
Figure 7-3 .
Figure 7-3: Updated Camera Name in Camera Name Field
NOTE:
If the Camera Detection Wizard is run again at a later time,
the name will be changed back to the default name (i.e.,
Camera1.)
7.3 Changing the ST-133 Line Voltage and Fuses
The appropriate voltage setting for your country is set at the factory and can be seen on
the power module. If your voltage source changes, you will need to change the voltage
setting and you may need to change the fuse configuration. Refer to
Table 7-2 for fuse
rating information.
CAUTION!
!
Use proper fuse values and types for the controller and
detector to be properly protected.
4
4
11
-00
9
7_
0037
Table 7-2: Fuse Ratings
Input Voltage
Fuse
Type
Left Right
100/120 V
AC
0.75 A 2.50 A Slo-Blo
220/240 V
AC
0.30 A 1.25 A Slo-Blo