Teledyne Princeton Instruments PI-MTE, System Manual

Page: 12 / 118

12 PI-MTE System Manual Issue 6
1.6 Precautions
To prevent permanently damaging the PI-MTE system, observe the following
precautions at all times.
CAUTION!
!
1. Do not mix and match ST-133 Controllers and cameras.
The controller shipped with your camera has been
modified to operate with the camera included in the
PI-MTE system you ordered. The System ID number on the
camera and the controller serial labels must be the same.
2. Always switch off and unplug the ST-133 Controller
before changing your system configuration in any way.
3. The CCD array is very sensitive to static electricity.
Touching the CCD can destroy it. Operations requiring
contact with the device can only be performed at the
factory.
4. If you are using high-voltage equipment (such as an arc
lamp) with your camera system, be sure to turn the
controller power ON LAST and turn the controller
power OFF FIRST.
5. Use caution when triggering high-current switching
devices (such as an arc lamp) near your system. The
CCD can be permanently damaged by transient voltage
spikes. If electrically noisy devices are present, an
isolated, conditioned power line or dedicated isolation
transformer is highly recommended.
6. Never connect or disconnect any cable while the
system is powered on. Reconnecting a charged cable
may damage the CCD.
7. Never prevent the free flow of air through the Model
ST-133 by blocking the air vents.
8. Never operate a liquid-assisted PI-MTE camera with
coolant at a temperature below that specified for it.