Teledyne Everywhereyoulook IsoPlane 320A, Manual

Page: 35 / 90

31
Chapter 5: IsoPlane Setup
This chapter provides information about the initial setup and configuration of an IsoPlane
spectrograph.
REFERENCES:
For detailed information about the operation of an IsoPlane
spectrograph, refer to Chapter 6, Operation , on page 43.
5.1 Unpack and Inspect Equipment
Carefully unpack and examine the IsoPlane and all purchased accessories.
NOTES:
1.
Report any damage immediately to the carrier and to
Princeton Instruments.
2.
Save all packing material.
5.2 Initial Setup Procedure
Perform the following procedure to setup the IsoPlane for the first time:
1.
Position the IsoPlane where it will be used.
2.
Connect the power supply shipped with the IsoPlane to the
POWER
connector located
on the side of the IsoPlane. See Figure 5-1 .
Figure 5-1: External Connector Panel
The power supply pr5 V
DC
for the control logic and +24 V
DC
for the motor
drives.
3.
With the power supply switch in the off position, connect the line cord provided with
the IsoPlane to the power supply and the AC line. The power supply will operate with
line voltages between 100 and 240 V
AC
, 50/60 Hz.
4.
The IsoPlane is designed to be controlled primarily through Princeton Instruments’
LightField
®
or WinSpec data acquisition and control software when operated with a
Princeton Instruments detector. Connect the USB port of the IsoPlane to the USB port
on the control computer using the USB cable provided.
The RS-2332 interface may also be used if a USB port is not available. If using the
RS-232 interface, configure the appropriate port on the host computer as described in
Section D.1, Communication Configuration Settings , on page 71.
44
11-0
143_0
002
POWER