Teledyne Everywhereyoulook IsoPlane 320A, Manual

Page: 48 / 90

44
6.3 Using LightField
Launch LightField after verifying that the detector and IsoPlane are both connected to the
host computer and are turned on. When LightField boots it will look for available devices
and will load their icons in the
Available Devices
panel. Before you can design a new
experiment or run an existing one, the appropriate device icons must be dragged into the
Experiment Devices
panel. Once there is at least one device, the
Experiment Settings
panel will be populated with expanders for groups of experiment settings.
NOTE:
If the IsoPlane ( 320A ) icon is the only device in the Experiment
Devices panel, the Spectrograph expander will be the only
expander in the list. When you drag a detector into the panel, the
Calibration expander and all of the detector- related expanders
will be displayed.
6.3.1 Define the Detector and Spectrograph
Peform the following procedure to define a detector and spectrograph:
1.
After LightField opens, an icon representing the detector should be visible within the
Available Devices
area. In Figure 6-1 , the detector is a PIXIS:100B eXcelon
®
.
Figure 6-1: Typical LightField Available Devices Panel
2.
Drag the desired icon into the
Experiment Devices
area. See Figure 6-2 .
4411-
0143
_002
8