Teledyne ADFM Hot Tap, Installation And Operation Manual, Page: 31 / 116

ADFM® Flow Meter
Section 2 Setup and Installation
2-11
Irregular channels
(multi-point) 6. Irregular Channel Type

For irregular shapes, select Irregular > Configure Points
(Figure 2-10).
Figure 2-10 Irregular Channel Configure window
7. Enter the Width/2 (half the width) and its corresponding
Height for ten different points (Heights) in the channel.
Point 1 represents the lowest point in the channel. As you
enter the widths/2 and their corresponding heights, click
Update Display to see them represented graphically (Fig-
ure 2-10).
8. When you are finished entering the points, the picture
should be an approximate representation of the channel’s
geometry. Make any necessary corrections and click OK.