Teledyne 2105, Installation And Operation Manual, Page: 45 / 98

2105 Interface Module
Section 2 Installation and Operation
2-27
The HyperTerminal program will re-display the “DIAL” window.
Figure 2-30 HyperTerminal Dial window
To begin communication to your sampler, Click “Dial”. The PC
will call and connect to the 2105. Once connected, follow the
steps in the Table 2-2 below. Note that <CR> (carriage return)
means to press the Enter key.
Table 2-2 Sampler Pass Thru Mode Connection Steps
Step Command Function Description
1
????
(Hold the shift key and press the “?” key repeatedly until you see a response
.)
This logs into the 2105.
2
SP <CR> Accesses the “System Process” menu
3
60 <CR>
60 enters the ADFM settings
4
ADFM> Type ACOM Opens the “Pass thru” connection
5
????
(Hold the shift key and press the “?” key repeatedly until you see a response
.)
This logs into the 6712 or Avalanche
6
MENU <CR> Enters the “Sampler Control” menu
7
CONTROL <CR>
Accesses the sampler’s keypad.
8

,

,

,

, <CR>
Arrow keys are used to navigate the displays just as the arrow keys on
the sampler’s keypad.
9
ESC Key Used at any time, to return to the previous screen
10
q <CR> Exits the “Control” Menu
11
q <CR> Exits the “Menu” mode
12
CTRL+C
Closes 2105 Pass-thru Connection
13
q <CR> Exits the “ADFM” Menu
14
q <CR> Closes the HyperTerminal connection to the 2105