© Telect, Inc. All rights reserved. 148326 09.08.16
1.509.926.6000 :: telect.com
21
LTX Patch and Splice Panel
LTX Patch and Splice Panel
Fiber :: Install guide
Figure 4-6 - Route Pigtail Fibers in the Splice Tray
Refer to
Figure 4-6
for this procedure.
Pigtail fi bers route from connectors that connect adapters to jumpers and patch the fi bers in the LTX panel. Refer to
Section 4.1.5,
Install
Pigtail Fiber Connectors
before completeing this section.
NOTE: Ensure designation label is marked with correct designation information.
1.
Route a pigtail fi ber from connector into the splice tray at the opposite corner entrance from where IFC fi bers route into the tray.
NOTE: Keep track of individual fi bers entering the splice tray. Place each individual fi ber from the fi rst 12 fi bers entering the tray into
separate entrance slots. Place the next 12 fi bers on top of the fi rst twelve and the third group of 12 fi bers on top of the fi rst and second
groups. Up to 36 fi bers can enter the tray (three fi bers will end up being in each entry slot.)
2.
Loosely route each individual pigtail fi ber through the tray maintaining a bend radius of no less than 7 inches. Keep the fi ber beneath the
protective tabs along the edge of the splice tray.
3.
Route the fi ber through the tray around the sleeve holder position and into the corresponding sleeve holder about halfway so that fi ber
ends do not touch the IF fi bers.
4.
For each fi ber routed into the tray, repeat this section (until 36 pigtail fi bers have been routed into this splice tray). As fi bers are added
record locations on the designation label attached to the panel door.
5.
After completing this section. repeat
Section 4.1.4,
Route Protected 12-Strand Ribbon Fiber in LTX Panel Slack Area
, and then
Section 4.1.5,
Install Ribbon Fibers in the Splice Tray
, and then this section (
Section 4.1.6,
Route Pigtail Fibers in the Splice Tray
)
again for the next splice trays working from lowest tray to the highest tray.
4.1.6 Route Pigtail Fibers in the Splice Tray
Ribbon Fibers route in
and through splice tray
to sleeve holders
Pigtail Fiber
Connectors
Pigtail Fiber
Routing in the
LTX Panel
Route Pigtail
Fiber into Splice
Tray
Route Fibers in
Splice Tray to
Sleeve Holders
Protective
Tab
Entrance
Slots
Splice
Tray
LTX Panel
Top View
Front (partial)
LTX Panel
Top View
Rear
