Telecast Fiber Systems – CopperHead 3400 Transceiver System User Guide –
Preliminary Version
Page 29
A
Belden
Brand
Area D – Signal Strength Indicators/Setup
13) Signal Strength Readout in dBm
This display changes between display modes when selected
14) Readout Function Indicator
BASE RX
– Optical Link signal strength received at Base
Station from Camera Unit
CAM RX
– Optical Link signal strength received at Camera
from Base Station
DIAG
– Digital display is in Diagnostic mode
15) Select Button
Chooses between three modes of operation
For details on how the setup/Diagnostic functions operate
please see Page 70.
Area E – Status/Power Indicators
Note: Hybrid Power Indicators are
present only on a hybrid power unit
16) Power Switch & Power Indicator
Toggle switch to enable or disable Base Station power.
LED turns
Green
when on/off switch is changed to the
ON
position. With a hybrid power system (power supplied by the
Base Station) this switch will control power to the Camera and
the Camera Unit
For the hybrid system to be properly powered, the AC Mains
switch on the rear of Base Station must be in the on position.
17) Hybrid Power Indicators
The Hybrid Power indicators are only applicable to units with
the internal power supply (for configurations using the HDX or
MPS power supplies – see Pages 49 & 50).
CAMERA POWER
- indicates that high voltage is applied to
power the camera.
Green
when high voltage is being supplied to the camera.
Off
when there is no high voltage applied to the camera
CABLE OPEN
- indicates that the high voltage cable is open
or there is no high voltage cable connected.
Green
when the cable is properly connected from the Base
Station to the camera.
Red
when there no cable connected to the camera or the cable
is connected but open.
High voltage will not be applied to the camera until the open
condition is corrected.
CABLE SHORT
- indicates that the high voltage cable
connected is shorted.
Summary of Contents for CopperHead 3400
Page 2: ......
