Telecast Fiber Systems – CopperHead FS790 ProHD Transceiver Sys
Note: Hybrid Power Indicators are
present only on a hybrid power unit
CopperHead FS790 ProHD Transceiver System User Guide
Page 38
Note: Hybrid Power Indicators are
present only on a hybrid power unit
15) Hybrid Power Indicators
The Hybrid Power indicators are only a
with the internal power supply (for configurations using the
optional MPS power supply – see Pages
CAMERA POWER
- indicates that high voltage is applied to
power the camera.
Green
when high voltage is being supplied to the camera.
Off
when there is no high voltage applied to the camera
CABLE OPEN
- indicates that the high voltage cable is open
or there is no high voltage cable connected.
Green
when the cable is properly connected from the
Station to the camera.
Red
when there no cable connected to the camera or the cable
is connected but open.
High voltage will not be applied to the camera until the open
condition is corrected.
CABLE SHORT
- indicates that the high voltage cable
connected is shorted.
16) Power Switch & Power Indicator
Toggle switch to enable or disable Base Station power.
LED turns
Green
when on/off switch is changed to the
position. With a hybrid power system (power supplied by the
Base Station) this switch will control power to the Camera and
the Camera Unit
For the hybrid system to be properly powered, the AC Mains
switch on the rear of Base Station must be in the on position.
See next page for details.
tem User Guide –
110124V4JH
The Hybrid Power indicators are only applicable to units
(for configurations using the
Pages 47 & 49).
indicates that high voltage is applied to
when high voltage is being supplied to the camera.
ere is no high voltage applied to the camera
indicates that the high voltage cable is open
when the cable is properly connected from the Base
nnected to the camera or the cable
High voltage will not be applied to the camera until the open
indicates that the high voltage cable
le switch to enable or disable Base Station power.
when on/off switch is changed to the
ON
. With a hybrid power system (power supplied by the
Base Station) this switch will control power to the Camera and
ybrid system to be properly powered, the AC Mains
switch on the rear of Base Station must be in the on position.
