Telecast Fiber Systems – CopperHead FS790 ProHD Transceiver System User Guide –
110124V4JH
Page 19
Chapter 3. Installation of the CopperHead KA-F790 Camera Unit on the
JVC ProHD GY-HM790 Video Camera
This chapter describes the physical installation of the CopperHead FS-790 Transceiver System. The following
areas are covered:
1) Initial Installation of the CopperHead KA-F790 Camera Unit to the camera
2) Mounting of the optional Power Wafer Unit to the CopperHead FS-790 Camera Unit
3) Relocation of the CopperHead FS-790 Base Station Fiber connector from the back panel to the front
panel
3.1. Initial Installation of the CopperHead KA-F790 Camera Unit to the Camera
This section describes the physical installation of the CopperHead KA-F790 Camera Unit to the camera.
Installation should only be performed by a technically qualified individual. Typically the installation will be
performed by the technical staff at your JVC Dealer, System Integrator or a technician on your organization’s
staff. A qualified and experienced individual should be able to accomplish the installation in about 15
minutes.
The installation encompasses the following steps:
1) Verification of all components
2) Relocation of the Battery Adaptor from the back of the Camera to the KA-F790 Camera Unit
3) Installation of the Camera Unit Mounting Plate on to the camera
4) Installation of the Connector Adaptor Plate and connection of required cables
5) Mounting of the Camera Unit on to the Mounting Plate
6) Operational test of the installed system
You will need a clean flat surface upon which to work and a medium Phillips screwdriver to perform the
installation of the Camera Unit on to the Camera.
This User Guide illustrates the installation of a Camera Unit on to a Camera equipped with an Anton Bauer
type battery. The V-Mount system installation is identical with the very minor wiring connector differences.
