Telecast Fiber Systems – CopperHead FS790 ProHD Transceiver Sys
Installation Of The Connector Adaptor Plate And Connec
CopperHead FS790 ProHD Transceiver System User Guide
Page 24
Installation Of The Connector Adaptor Plate And Connection Of Required Cables
1) Position the Connector Adaptor Plate into the
cutout as shown
2) Carefully push the Adaptor Plate onto the
existing 68 pin connector in the Camera
3) Secure the Adaptor plate to the Camera using
the two provided lock washer screws
over tighten these screws so as to prevent
damage to the Adaptor plate
1) Position the Camera Unit in front of the Camera
and Mounting Plate as shown
2) Position the various connectors so that they do
not interfere with each other
a. White Power Connectors
b. 68 Pin Ribbon Cable
c. HD/SDI Video Cable
3) Position the two unused black voltage and
battery data connectors so that they are out of
the way
1) Connect the two white Power Connectors (A)
2) Carefully seat the 68 pin ribbon cable on to the
Camera Adaptor Plate (B)– line up the connector
key and open the locking levers on either side of
the Camera Adaptor
3) Only slight pressure is needed to firmly connect
the ribbon cable if the key is properly aligned
once seated the locking levers will snap closed
and secure the connector
4) Connect the HD/SDI Cable (C) to the Camera
video connector through the Video Connector
cut out
tem User Guide –
110124V4JH
tion Of Required Cables
Position the Connector Adaptor Plate into the
Carefully push the Adaptor Plate onto the
existing 68 pin connector in the Camera
Secure the Adaptor plate to the Camera using
the two provided lock washer screws – Do not
over tighten these screws so as to prevent
Position the Camera Unit in front of the Camera
Position the various connectors so that they do
White Power Connectors
68 Pin Ribbon Cable
Position the two unused black voltage and
battery data connectors so that they are out of
Connect the two white Power Connectors (A)
Carefully seat the 68 pin ribbon cable on to the
line up the connector
key and open the locking levers on either side of
Only slight pressure is needed to firmly connect
the ribbon cable if the key is properly aligned –
once seated the locking levers will snap closed
Connect the HD/SDI Cable (C) to the Camera
video connector through the Video Connector
