CHAPTER 9: CONFIGURATION MENU
All configuration settings require access to the receiver circuit board(s).
RISK OF ELECTRIC SHOCK
The receiver must only be opened by qualified installers or authorized
personnel.
Make sure the power supply is switched off before opening the receiver.
Failure to follow these instructions could result in death, serious injury,
or equipment damage.
1. Remove the front cover of the receiver. Use a screwdriver to remove the
screws.
2. Power the receiver up.
3. The power LED lights (yellow).
4. Proceed with the configuration instructions of your choice.
9.1 M enu mode
To access the different menus, press the
Function
button a predefined number of
times, according to the following table. The different menus are identified by the
function LEDs 1–4 (see
).
: LED is lit.
: LED is off.
Menu
To access the menu,
press the Function
button…
Function LEDs light
LED 1
(red)
LED 2
(yellow)
LED 3
(green)
LED 4
(orange)
Register/ erase transmitters once
Show/ change Latching/
momentary functions
2 times
Show settings
3 times
Show/ change Operating
mode
4 times
Active
Load select
(extended menu)
4 times then press
Select
button once
IM-PN-RX107-CERT-01pre4
41
PRELIMINARY
