4. Press the
Function
button to enable/ unable the Load setting.
Function LEDs 3 (green) and 4 (orange) light when a
Load
has been activated.
They are off when no Load has been selected.
5. Press the
Select
button to move to the next available
Load
(Load B).
The corresponding status LED flashes and the Load can be activated.
6. Repeat step 4–5 for
Loads
C–D.
7. Press the
Select
button to confirm and store the new configuration.
The receiver exits "Active load Select" mode and returns to normal operation.
9.6 Log a transmitter ou t
NOTE: Only for continuous radio mode.
If a transmitter has been lost or seriously damaged, use the replace procedure on
the transmitter whenever possible.
Function LED1 (red) and 4 (orange) are lit to indicate that one or more transmitter
(s) are registered in the receiver and that one transmitter is logged in.
1. Press the receiver
Select
button for approx. 4 seconds.
Function LED 4 flashes fast (orange).
2. Release the
Select
button.
Function LED 4 goes off.
All function LEDs light briefly. The logged in transmitter has been logged out. The
receiver returns to normal operation. Any registered transmitter can now log in.
9.7 Erase al l registered transmitters
NOTE: The following instructions will erase all registered transmitters from the
receiver.
NOTE: An erased transmitter cannot be logged in to the receiver until it has been
registered in the receiver again.
1. Press the receiver
Function
button once
Function LED 1 lights (red).
2. Press the receiver
Select
button.
Relay LEDs light (red)
IM-PN-RX107-CERT-01pre4
47
PRELIMINARY
