![Tele Radio R23-01 Installation Instructions Manual Download Page 52](http://html1.mh-extra.com/html/tele-radio/r23-01/r23-01_installation-instructions-manual_1079588052.webp)
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
This radio transmitter has been approved by Industry Canada to operate with the
antenna types listed below with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are
strictly prohibited for use with this device.
Gain of antenna: 3.0 dBi max.
Type of antenna: 50 ohm, Omni-directional
Le présent émetteur radio a été approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés ci-dessous ayant le gain admissible maximal et
l'impédance requise pour chaque type d'antenne indiqué. Les types d'antenne non
inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
Gain d'antenne: 3.0 dBi maximum
Type d'antenne: 50 ohm, omnidirectionnel
To satisfy IC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during
device operation. To ensure compliance, operation at closer than this distance is
not recommended.
Afin d'assurer la conformité aux exigences de la IC en matière d'exposition aux RF,
une distance de séparation d'au moins 20 cm doit être maintenue entre l'antenne
de cet appareil et toute personne à proximité pendant le fonctionnement de
l'appareil. Pour assurer le respect de ces exigences, il n'est pas recommandé
d'utiliser l'appareil à une distance inférieure à celle-ci.
1 1 .2 .3 F C C /I C L A B EL S
The radio module in this product is labeled with its own FCC ID and IC numbers.
The FCC ID and IC numbers are not visible when the radio module is installed
inside another device. Therefore, the outside of the device into which the module
is installed must also display a label referring to the enclosed radio module. The
final end device must be labeled in a visible area with the following:
“Contains FCC ID: ONFC-1902A
“Contains IC: 4807A-C1902A
The FCC and IC numbers are found on the product label.
52
IM-PN-RX107-CERT-01pre4
PRELIMINARY