the relay deactivates. Setting a relay to latching means that the relay becomes
active when a button is pressed and remains active until the button is pressed
again.
8 .3 .1 S ET MO MEN T A RY O R L A T C H I N G REL A Y F UN C T I O N S
The settings options depend on the selected
Operating mode
.
NOTE: The number of relays that can be set to latching varies depending on the
selected
Operating mode
.
NOTE: It is not possible to program latching relays in Operating mode 255.
1. Press the
Function
button twice.
The function LED 2 lights (yellow). The lit relay LEDs indicate which relays
that have been set to latching.
2. Press the
Select
button.
The first relay LED that can be set to latching/momentary will flash fast.
3. Press the
Function
button to change the setting for the current relay. Relays
can be set to latching or momentary and the current setting is indicated by
the function LED 2 (yellow).
Function LED 2
Indicates
○
Momentary
●
Latching
: LED is lit.
: LED is off.
4. Press the
Select
button to confirm the setting and go to the next relay.
5. Repeat until all relays have been set to either momentary or latching.
After the last relay has been programmed (depending on operating mode and
hardware configuration), the receiver will exit to normal operation.
8 .4 Logou t f u nction
NOTE: Only for continuous radio mode.
Logging out means stopping the communication between the transmitter and the
receiver.
If a transmitter has been lost or seriously damaged, use the replace procedure on
the transmitter whenever possible.
IM-PN-RX107-CERT-01pre4
39
PRELIMINARY
