elmeg IP120 / en / elmegIP120_v1 / starting.fm / 01.08.2012
V
e
rsion 2, 27.0
5
.2010
16
elmeg IP120
Teldat
First steps
Connecting a device to the mains power supply (if required)
Your elmeg IP120 is supplied with sufficient power by PoE (Power over Ethernet) and does not
need to be connected to the mains power supply.
Prerequisite:
The device is connected to an
Ethernet switch with PoE functionality (PoE class IEEE802.3af ) (
To connect your device to the mains power supply, if required, a power adapter is supplied with
three different plug-in modules for Europe, Great Britain and the USA. First attach the appropri-
ate plug-in module to the power supply unit.
§§1§§
Slide the required plug-in module into the recess on the underside of the power supply unit
until it clicks into place.
§§2§§
To remove the plug-in module again, press on the button marked
Push
and pull the plug-in
module out of the power supply unit.
§§1§§
Connect the power adapter to the port on the rear of the phone.
§§2§§
Then
insert the plug into the mains socket.
Warning
Use only the power adapter
supplied
.
Please note
You can safeguard your device against theft by fitting a Kensington lock. The corresponding
hole can be found on the rear of the device (
§§3§§
).
Europe
Great Britain
USA
1
2
2
1
3
