Vers. 007
Energy 4004 D
GB
11
6.2 Turning off the generating set
To stop the generating set, place the “ON/OFF”
switch in its OFF position (Fig. 12 ref. 1)
The generating set has
an internal combustion engine; therefore the
fuel used is highly flammable.
The exhaust gases are conveyed under the
casing; their temperature, inevitably, is quite
high, even though they are mixed with cool-
ing air.
Do not touch the casing near the exhaust,
and do not put your hands or other objects
inside the casing.
6.3 Forbidden use
The generating set must
be installed and used only by qualified per-
sonnel, authorised according to the manufac-
turer’s instructions. The generating set must
be used only and exclusively to produce elec-
trical power on vehicles provided with an
electrical system made according to stan-
dards and depending on the quantity of
power delivered.
6.4 Advice
To make the best use of the generating set, re-
member that even small overloads - if they last
for some time - will make the temperature cut-off
contact open (Fig. 13 ref. 1).
During the running-in period, do not subject the
new motor to a load higher than 70% of the rated
load, at least for the first 50 running hours.
6.5 Control and alarm functions (Fig. 14)
2 Display
: when the generating set has start the
total running hours will be displayed. Press the
changing key Fig. 14 ref. 9 to display the partial
running hours of the generating set after the last
change of the motor oil.
3 High temperature indicator
: this warning light
will light up when the temperature of the generat-
ing set goes over its safety value; the motor will
olso stop.
4 Motor oil minimum pressure indicator:
this
warning light will light up to indicate that the level
of oil in the motor has gone below the minimum
level.
5 Motor startup failed
: this warning light will
light up to indicate that the generating set has not
started, after all four attempts at starting have fai-
led.
7 Change oil
: this warning light will light up when
the motor has reached 100 running hours after
the last change of oil. Every time the oil is chan-
ged, the After-sales service must reset the timer
at zero.
8 Fuel reserve
: this warning light will light up
when the fuel level inside the tank has gone be-
low its reserve level (about 4 litres). Only aplied
when ptional tanck is fitted
9 Display changeover switch
: press this to dis-
play the running hours which have elapsed since
the last time the motor oil was changed.
10 Reset
: When the display shows any charac-
ters without logic, the panel is to be reinitialised.
Press the Reset key and, holding it down, switch
on the panel. When 4 zeroes (0000) are shown
on the display, the panel is reinitialised.
14
13
