Merging TLA700 Modules
TLA700 Series Logic Analyzer Installation Manual
27
1.
Determine which modules will reside in the highest-numbered slots in a
single mainframe.
2.
Place the merge connector of these modules in the extended position. The
module in the lowest-numbered slot must have the merge connector in the
recessed position.
Use Figure 17 as a guide for determining the location of the master module
with the merged module set. Even though Figure 17 shows a five module
set, you can still use the illustration to position the master module with
respect to the slave module. For example, if you have a two module set, the
master module is located in the lower-numbered slot, and the slave module is
in the higher-numbered slot.
M
A
S
T
E
R
S
L
A
V
E
2
S
L
A
V
E
4
S
L
A
V
E
1
S
L
A
V
E
3
Figure 17: Location of modules in a merged system
Merging TLA7Axx/TLA7NAx Logic Analyzer Modules
Complete the following steps to create a merged module from any combination
of two to five individual TLA7Axx and TLA7NAx modules:
1.
Place the module on the right side.
2.
Using a Torx T-10 screwdriver, remove the two screws holding the merge
connector to the module (see Figure 18).
