Taking Measurements
Acquiring Data
The application automatically sets the oscilloscope settings for the selected
measurements. To acquire data from the oscilloscope, follow these steps:
1.
Select the
command button to run the application.
2.
The application displays the message “Please press OK when correct
waveform is acquired” for live signals
.
Figure 24: Confirm waveform screen
3.
If you select the Cursor Mode, the application displays the message “Place
the Cursors at the start and end position of the USB packet.” Press OK when
done.
Figure 25: Place cursors screen
4.
If you select the Inrush measurement, the application displays the message
in the following figure:
TDSUSB2 Universal Serial Bus Measurement Package
49
Summary of Contents for TDSUSB2
