Tektronix TDSUSB2, Manual

Page: 185 / 250

Reference
Table 36.Error Code descriptions (cont.)
JK and KJ Jitter Measurement Errors
E304
Number of bits is not sufficient
to calculate JK jitter More than four Cross-Over points are
expected by the algorithm Try acquiring the signal again by pressing
Run button
E305 Number of bits is not sufficient
to calculate KJ jitter More than four Cross-Over points are
expected by the algorithm Try acquiring the signal again by pressing
Run button
Report Generation Errors
E401 Error generating report in Plug
Fest format This error is generated if there are no
results to process Check if the valid directory and file name is
selected for report generation. Check if the
file name extension is .htm. Try generating
the report again by pressing Run button
E402 Error Generating report in Tek
format This error is generated if there are no
results to process Check if the valid directory and file name
are selected for report generation. Check if
the file name extension is .htm. Try
generating the report again by pressing
Run button
E403 Error Generating report in CSV
format This error is generated if there are no
results to process Check if the valid directory and file name s
are selected for report generation. Check if
the file name extension is .htm. Try
generating the report again by pressing
Run button.
E404 No results present to generate
report This error is generated if there are no
results present for the USB Inrush,
Droop and Signal Quality Check
Reports
Press the Run button to get the results and
try again
E405 Could not generate a report as
the Eye diagram is missing This error is generated if there is no
eye diagram found in
C:\TekApplications\TDSUSB2\temp
Press the Run button and perform the
measurements again
E406 Could not generate report as
Waveform plot is missing
This error is generated if there is no
waveform plot found in
C:\TekApplications\TDSUSB2\temp
Press the Run button and perform the
measurements again
Eye Measurements
E601 The maximum zoom factor has
been reached
N/A Press the Reset button or use the Zoom
out feature.
E602 Signal not proper, check the
signal This is a check to confirm the acquired
waveform Try acquiring the correct waveform
Inrush Measurements
E501 Final data point is still above the
inrush threshold The signal has not fallen below the
Inrush threshold level Try acquiring the correct waveform
TDSUSB2 Universal Serial Bus Measurement Package 171