Tektronix TDS 820, Manual

Page: 16 / 94

Brief Procedures
Appendix C: Performance Verification
Performance Verification
1Ć2
Throughout these procedures the following conventions apply:
H
Tighten all SMA connectors to 8.5 inch pounds (0.96 N · m).
H
Each test procedure uses the following general format:
Title of Test
Equipment Required
Prerequisites
Procedure
H
Each procedure consists of as many steps, substeps, and subparts as
required to do the test. Steps, substeps, and subparts are sequenced as
follows:
1. First Step
a. First Substep
H
First Subpart
H
Second Subpart
b. Second Substep
2. Second Step
H
In steps and substeps, the lead-in statement in italics instructs you what
to do, while the instructions that follow tell you how to do it: in the exam-
ple step below,
“Initialize the oscilloscope” by doing “Press save/recall
SETUP. Now, press the main-menu button.”
Initialize the oscilloscope: Press save/recall SETUP. Now, press the
main-menu button Recall Factory Setup; then the side-menu button
OK Confirm Factory Init.
H
Where instructed to use a front-panel button or knob, or select from a
main or side menu, or verify a readout or status message, the name of
the button or knob appears in boldface type: “press SHIFT; then AC-
QUIRE MENU”, “press the main-menu button Slope”, or “verify that the
status message is
Pass”.
The symbol at the left is accompanied by information you must read
to do the procedure properly.
Conventions