Tektronix SPG8000A, User Manual

Page: 180 / 243

166 SPG8000A User Manual
about system faults and alerts. This menu is for viewing status only and
no changes to the instrument settings can be made from this menu.
•
SYSTEM : Use to view and configure instrument settings such as
network parameters, SNMP traps, GPI alarms, installed options,
display brightness, beeper control, and hardware/firmware versions.
You can also use this menu to perform firmware upgrades, save and
recall presets, and view diagnostic results.
•
TIME : Use to set instrument time parameters in submenus, such as the
time of day source, the time zone offset, the daylight savings time
schedule, the program time, and the jam sync settings.
•
PTP : Use to view or change the primary and secondary PTP settings
for the instrument.
Menu control buttons
Use these buttons to control the menu display:
•
Arrow buttons (▲, ▼, ◄, and ►). Use these arrow buttons to
move through the available menu items.
•
ENTER button . Use the ENTER button to enable the selected
menu item or to enter a submenu.
•
BACK button
. Use the BACK button to return to the previous menu
item.
LCD display readouts
The LCD display is a two - line, 40 - character -per- line display. Almost all menus
have two lines of text, where the first line shows the current position in the current
menu, and the second line shows the current selection (if there is not a submenu).
If nothing is on the second line, press ENTER to access the corresponding
submenu.
The readouts on the LCD display vary depending on the instrument setting and
which menu is being accessed. Figure 60 shows some example display readouts.
Figure 60: Example display readouts