Tektronix SPG8000A, User Manual

Page: 107 / 243

SPG8000A User Manual 93
Figure 25: SDI Overlay Circle settings
Note: The position of the circle overlay is referenced from the center of the
active picture.
These settings are available for the Circle overlay:
•
Circle Enable : Select this check box to enable the Circle overlay and to
enable the Circle overlay control settings.
•
X Position : Enter the horizontal position of the circle. The position is set
as a percentage of active picture width. You can set the value from -
50.0% to 50.0% in 0.1% steps.
•
Y Position : Enter the vertical position of the circle. The position is set as
a percentage of active picture height. You can set the value from - 50.0%
to 50.0% in 0.1% steps.
•
Diameter : Enter the diameter of the circle. The diameter is set as a
percentage of active picture height. You can set the value from 0.0% to
100.0% in 0.1% steps.
Burnt-In Timecode overlay
settings
Use these settings to overlay a time code readout (HH:MM:SS;frames) on the
output test signal and set the size and position of the time code readout. Figure 26
shows the SDI Overlay Burnt -In Timecode submenu.
Figure 26: SDI Overlay Burnt-In Timecode settings
These settings are available for the Burnt - In Timecode overlay:
•
BITC Mode : Use the drop- down list to disable the B urnt-In Timecode or
select a Large or Small time code.
•
X Position : Enter the horizontal position of the time code. The position is