Important safety information
Do not operate in wet/damp conditions.
Be aware that condensation may occur if
a unit is moved from a cold to a warm environment.
Do not operate in an explosive atmosphere.
Keep product surfaces clean and dry.
Remove the input signals before you clean
the product.
Provide proper ventilation.
Refer to the installation instructions in the manual for
details on installing the product so it has proper ventilation.
Slots and openings are provided for ventilation and should never be covered or
otherwise obstructed. Do not push objects into any of the openings.
Provide a safe working environment.
Always place the product in a location
convenient for viewing the display and indicators.
Avoid improper or prolonged use of keyboards, pointers, and button pads.
Improper or prolonged keyboard or pointer use may result in serious injury.
Be sure your work area meets applicable ergonomic standards. Consult with an
ergonomics professional to avoid stress injuries.
Use only the Tektronix rackmount hardware speci
fi
ed for this product.
Probes and test leads
Before connecting probes or test leads, connect the power cord from the power
connector to a properly grounded power outlet.
Keep
fi
ngers behind the
fi
nger guards on the probes.
Remove all probes, test leads and accessories that are not in use.
Use only correct Measurement Category (CAT), voltage, temperature, altitude,
and amperage rated probes, test leads, and adapters for any measurement.
Beware of high voltages.
Understand the voltage ratings for the probe you are
using and do not exceed those ratings. Two ratings are important to know and
understand:
The maximum measurement voltage from the probe tip to the probe reference
lead.
The maximum
fl
oating voltage from the probe reference lead to earth ground
These two voltage ratings depend on the probe and your application. Refer to the
Speci
fi
cations section of the manual for more information.
WARNING.
To prevent electrical shock, do not exceed the maximum measurement
or maximum
fl
oating voltage for the oscilloscope input BNC connector, probe
tip, or probe reference lead.
6
MDO3000 Installation and Safety Instructions
