left of center, the sweep is triggered on the
positive-going slope of the trigger signal as shown
by the positive-going waveform. When to the right
of center, the sweep is triggered on the negative
going slope of the trigger signal as shown by the
negative-going waveform.
@
HORIZ
MGF
VAR-Provides continuously variable
uncalibrated sweep magnification to at least 5
times the sweep rate indicated by the SEC/DIV con-
IIHIIITY
lll'VTCOUl'UII
.....
...
, ...........
•
mac 1llOMIAIIT0
1
l___TIUGGH__j
1480-11
Fig. 4. Partial side panel.
®
®
8
213 Operators
trol. The calibrated detent is at the fully counter
clockwise position.
SWP
CAL-Screwdriver adjustment to set the cali
brated sweep timing of the SEC/DIV control when
the HOR IZ MGF VAR control is in the calibrated
detent.
TRACE
ROTATE-Screwdriver adjustment to align
trace with the horizontal graticule line.
POS (Horizontal Arrow
Line)-Controls the horizon
tal position of the oscilloscope display.
REAR PANEL
Integral Voltage
Probe-Used by both the DMM and
oscilloscope for all voltage measurements. The alli
gator clip is the common connection.
Insulated Compartment-Used
to store the power line
plug when battery operated.
@
Summary of Contents for 200 Series
