
Maintenance
• To clean the Inversion Table, wipe down with a damp cloth. Do not use abrasive
cleaners or solvents.
Storage
• Remove the Angle Tether from the U-Bar located on the underside of the Table Bed.
• Pull the Height-Selector Locking Pin and slide the Main Shaft in all the way to the
last hole setting.
• Release and engage the Pin in the storage setting.
• Rotate the Table Bed opposite from use until it has turned 180 degrees and rests against
the Crossbar of the A-Frame.
• Pull up on the Spreader Arms to fold the A-Frame (Figure 26), leaving the A-Frame legs
open to a width of 12” for stability.
NOTE: This operation may pinch fingers if not done slowly and carefully.
Maintenance/ Storage
Tipping Hazard: For upright storage, leave A-frame open wide
enough to remain stable, or secure to the wall to prevent tipping.
In households with small children, the inversion table should be stored
flat on the floor, not upright.
WARNING
!
FIGURE 26