
Adjustments: Changing the Roller Hinge Setting
To adjust the Roller Hinge setting, you’ll need to fully remove the Table Bed from the A-Frame.
• Remove the Angle Tether from the U-Bar located on the underside of the Table Bed.
• Pull the Height-Selector Locking Pin and slide the Main Shaft in all the way to the last hole
setting.
• Release and engage the Pin in the storage setting.
• Rotate the Table Bed opposite from use until it has turned 180 degrees and rests against
the Crossbar of the A-Frame (Figure 23).
• With palms up, reach under and around each Roller Hinge, using your thumbs to release
the locks over the Pivot Pin (Figure 24).
• Lift both sides of the Table Bed out of the A-Frame at the same time. TIP: Rest the head
of the Table Bed on the floor for quick adjustment.
• Unlock the Cam Locks for each Roller Hinge. Change the Roller Hinges to the desired
setting (A, B or C).
NOTE: Refer to the Owner’s Manual for more information on finding your Roller Hinge Setting.
• Re-lock the Cam Locks (Figure 25). Replace the Roller Hinges into the hinge plates of the
A-Frame.
• Rotate the Table Bed back to the use position and re-adjust the Main Shaft height settings
for use.
Adjusting the Roller Hinge Setting
B
FIGURE 25
A
C
FIGURE 24
FIGURE 23