
Step 6
FRONT
1
2
3
1
2
Insert the Main Shaft (IA-1600) into the Table Bed (F1-1300)
• With the Height Adjustment Settings on the Main Shaft facing up, slide the end of the Main
Shaft into the Main Shaft Housing (Figure 15) on the Table Bed.
• Pull out the Height-Selector Locking Pin to allow the Main Shaft to slide in further and
release in the desired height setting. Refer to the Owner’s Manual for more information on
selecting your height setting.
• The Main Shaft
MUST REST
against the Crossbar of the A-Frame (Figure 16).
NOTE: The Crossbar prevents the Table Bed from rotating forward when the user steps on
the Ankle Comfort Dial. If the Main Shaft does not rest on the Crossbar as shown in Figure
16, then the Table Bed has been assembled backwards onto the A-Frame. This
MUST BE
CORRECTED
before use.
FIGURE 15
FIGURE 16
2
Main Shaft Housing
Main Shaft
1
3
Height-Selector Locking Pin
2
Crossbar
Proper Resting Position
1