TECO JSDE Series, Manual

Page: 5 / 62

5
Chapter 1 Checking and Installing
1-1 Checking Products
Our Servo Pack have already completely been functionally examined before leaving the factory. In order to protect the
products from the damage during transportation, please check the items below before open the pack:
y Check if the models of servo driver and motor are the same with the models of ordering.
(About the model explanation, please check the chapters below)
y Check if there are damage or scrape of the servo driver and motor.
(If there is any damage during transportation, do not power ON)
y Check if there are any assembly problem or loose parts in the Servo Drive and Motor
y Check if the Motor’s rotor and shaft can be rotated smoothly by hand
(The Servo Motor with Mechanical-Brake can not be rotated directly)
y
There must be the “QC” pass seal in each servo drive, if not, please do not proceed Power ON.
If there is any question under the situation above, please contact TECO’s Local sales representative or distributor for
more information.
1-1-1 Servo Drives Model Designation
JSD E – 15 A
TECO AC Servo
drive No.
Drive Series:
Series E
Drive Model:
10 / 15 / 20 / 30
AC Input Voltage
A : AC 220V
Input voltage phase:
□ ： Single / Three
3
：
3 Phase input
P.S : Maximum output power
10 : 200 W 20 : 750 KW
15 : 400 W 30 : 1 KW