Technosoft iPOS360x MX, Technical Reference, Page: 112 / 116


Technosoft 2013 100 iPOS360x MX Technical Reference
T
– is the slow loop sampling period expressed in [s]. You can read this value in the “Advanced”
dialogue, which can be opened from the “Drive Setup”.
6.12.5. Brushless motor with sine/cosine encoder on motor
The internal motor speed units are interpolated encoder counts / (slow loop sampling period). The
correspondence with the motor speed in SI units is:
For rotary motors:
] IU [ Speed _ Motor
T ion Interpolat periods _ Enc
] SI [ Speed _ Motor

  
 

4
2
For linear motors:
] IU [ Speed _ Motor
T ion Interpolat
accuracy _ Encoder
] SI [ Speed _ Motor



where:
Enc_periods
–
is the rotary encoder number of sine/cosine periods or lines per revolution
Encoder_accuracy
–
is the linear encoder accuracy in [m] for one sine/cosine period
Interpolation
–
is the interpolation level inside an encoder period. Its a number power of 2
between 1 an 256. 1 means no interpolation
Tr
–
transmission ratio between the motor displacement in SI units and load displacement
in SI units
T
–
is the slow loop sampling period expressed in [s]. You can read this value in the
“Advanced” dialogue, which can be opened from the “Drive Setup”