Technosoft iPOS360x MX, Technical Reference, Page: 105 / 116


Technosoft 2013 93 iPOS360x MX Technical Reference
No_steps
–
is the number of motor steps per revolution
No_µsteps
– is the number of microsteps per step. You can read/change this value in the “Drive
Setup” dialogue from EasySetUp.
Tr
–
transmission ratio between the motor displacement in SI units and load displacement in SI
units
T
– is the slow loop sampling period expressed in [s]. You can read this value in the “Advanced”
dialogue, which can be opened from the “Drive Setup”
6.4.4. Step motor open-loop control. Incremental encoder on load
The internal jerk units are load encoder counts / (slow loop sampling period)
3
. The transmission is
rotary-to-rotary. The correspondence with the load jerk in SI units is:
] IU [ Jerk _ Load
T lines _ encoder _ No
] SI [ Jerk _ Load

 
 

3
4
2
where:
No_encoder_lines
–
is the rotary encoder number of lines per revolution
T
– is the slow loop sampling period expressed in [s]. You can read this value in the “Advanced”
dialogue, which can be opened from the “Drive Setup”.
6.4.5. Step motor closed-loop control. Incremental encoder on motor
The internal jerk units are motor encoder counts / (slow loop sampling period)
3
. The correspondence
with the load jerk in SI units is:
] IU [ Jerk _ Motor
T Tr lines _ encoder _ No
] SI [ Jerk _ Load

  
 

3
4
2
where:
No_encoder_lines
–
is the motor encoder number of lines per revolution
Tr
–
transmission ratio between the motor displacement in SI units and load displacement in SI
units
T
– is the slow loop sampling period expressed in [s]. You can read this value in the “Advanced”
dialogue, which can be opened from the “Drive Setup”.