RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
Figure 4.6-6
8. Turn the machine over on one side.
9. Back off the 4 screws
d
using a Phillips
screwdriver.
10. Remove the cover
e
.
Figure 4.6-7
11. Push the connector plate
f
outward.
12. Unplug the CSafe connector
g
.
13. Remove the connector plate
f
.
14. Insert cable
6
CB-18 into the hole indicated
by the arrow, and run it alongside the CSafe
cable until it comes out on the display side.
Because the display column is
interrupted, as can be seen in Fig. 7, it
will be difficult for the cable to reach the
display. Therefore, route it along at least
the first section of column.
Figure 4.6-8
15. Fix the union connector
12
to the connector
plate
5
, securing it with its own lock-nut.
16. Plug the lower end of cable
6
TRM-18 into
connector
12
.
17. Reconnect the CSafe connector that was
unplugged previously.
18. Insert the connector plate
5
into the platform.
19.
Reassemble the guards disassembled
previously.
20. Turn the machine back upright.
Continued on following page
→
Page 4.7