Technogym New Bike EXCITE Plus, Technical Service Manual

Page: 214 / 237

- New Bike: Technical service guide - rev. 4.1
Page 9.20
9.3.5.3. COM.Fault
This is a counter which displays the number of serial communication errors between the high kit
and the low kit. It increases every time a communication error is detected. Move using the +/- keys
of the difficulty level until the display shows:
COM.FAULT X
To reset the counter, press
ENTER and the display will show:
RESET COM.FAULT?
press
ENTER to reset. Return to the upper level by pressing CANCEL for a few seconds.
9.3.5.4. Display errors
The errors log provides a series of information as listed in the following table for every error
generated by the equipment.
•
Error Code,
•
Type of error,
•
Current at the time of the error
•
Distance in Km at the time of the error.
During movement, the Brake Board is capable of detecting possible faults. The possible detected
errors are:
Error Code Description
1
OVERTEMPERATURE: this condition occurs when the temperature measured
by the board sensor exceeds 90°C.
8
OVERVOLTAGE: this condition occurs when the v12Vdc exceeds
13.7Vdc (only on powered models).
You move on to the subsequent error by pressing the + key of the difficulty level. Otherwise the
message containing the data of the current error is displayed again.