TechniSat DIGIT MF4-S, Operating Instructions Manual

Page: 16 / 53

6.4.1 Switching DiSEqC on or off
6.4.2 Setting the switching matrix
DiSEqC ( Di gital S atellite Eq uipment C ontrol) is a digital switching signal used to control
DiSEqC-compatible components via the antenna cable. If your external installation is equipped
with DiSEqC com- ponents, you must switch on the DiSEqC control:
> In this line, use the OK key to switch DiSEqC on or off .
As only one LNB can be addressed if the DiSEqC control is switched off, the menu is
restricted to the configuration of a single LNB.
Four switching criteria for the DiSEqC control are indicated in the
menu.
You receiver is pre-programmed, so that ASTRA will be received at
switching position A/A and Eutelsat at switching position B/A
of a multi-switch. Should your receiving installation be configured
differently, or should you receive other satellites, you can adjust the
set tings of your digital receiver to your antenna as follows.
> Use the
arrow keys
to select the DiSEqC switch position (1-4)
you wish to allocate to a particular satellite (e.g.. A/B 3
No Satellite
), and mark this line.
> Confirm by pressing OK .
A table will be displayed, allowing you to select from various
satellites.
> Use the
arrow keys up/down to mark the selected satellite.
The arrow keys up/down will move the marker up or down
the list one line at a time, use the arrow keys left/right to
move back or forward one page at a time.
If the satellite you are looking for is not included in the list, please select a reserve position,
designated
User 1
to
User 11
.
> Confirm by pressing green button/ ‘’Accept’’ button. The selected satellite will now be
added to the menu
Antenna Settings at the previously marked position.
Now proceed to enter the data in the menu An t e n n a
Settings , until the data in this menu
corresponds with that of your antenna installation. For any switching criteria not required select
the setting No Satellite .
16