41
En
gl
is
h
Settings
Using output correction function (LAPC)
(41)
Measuring the output signal of the
amplifier and correcting its output
(LAPC)
■
Preparation
•
Disconnect the headphones.
Test tone emitted during measurement
To ensure the measurement accuracy, the
speakers output a test tone at regular intervals.
(For approximately 2 minutes)
It is not possible to change the volume of the
audio being output while the measurement is in
progress.
1 Press [ ] to turn this unit on.
2 Press and hold [LAPC] until “LAPC
Measuring” is displayed.
This unit will start measuring the output signal
of the amplifier. Check that a test tone is
output from both the left and right speakers.
When the measurement is complete, amplifier
output correction will be automatically turned
on.
•
If you press [LAPC] while the measurement is
in progress, it will be cancelled.
•
If you connect headphones during amplifier
signal measurement or amplifier output
correction, it will be cancelled.
■
Turning on/off the output correction
function
Press [LAPC] to select “On”/“Off”.
•
“On”/“Off” is displayed.
Note
•
Depending on the type of the connected
speakers, the effect of the output correction
function may be minimal.
•
The corrected output remains in effect until you
measure the output signal again. When you use
other speakers, redo the measurement.
You can make the optimum adjustment according to
your own speakers.
