21
En
gl
is
h
Connections
Using iPhone/iPad/iPod
“With iPod”
With this method you will share the wireless
network settings of your iPod/iPhone/iPad with
this system.
•
Supported device:
iPhone/iPad/iPod touch (iOS version 5.0 or
later)
•
The following explanations are based on an
iPhone.
•
Make sure your iPhone is connected to your
home wireless network beforehand.
5V 2.1A
PHONES
VOLUM
USB cable
(supplied with iPhone/iPad/iPod)
1 Connect the iPhone to this unit with
the USB cable.
•
Use the USB cable supplied with iPhone/
iPad/iPod.
•
Unlock your iPhone before connecting.
2 Press [ ], [ ] on the remote control
to select “With iPod” and then press
[OK].
•
“Connecting Wi-Fi” is displayed.
3 Allow the iPhone to share the wireless
network settings.
•
When the connection is established,
“Success” is displayed.
-
“Fail” may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If “Fail” is still
displayed, try other methods (
19).
4 Press [OK] on the remote control to
exit the setting.
•
“
” is displayed.
Using the WPS PIN code
“WPS PIN”
If your wireless router supports WPS, you can set
up a connection by entering the WPS PIN code.
•
For details on how to enter the PIN code, refer
to the operating instructions of the wireless
router.
1 Press [ ], [ ] on the remote control to
select “WPS PIN” and then press [OK].
•
The PIN code is displayed. Complete step 2
within 2 minutes.
2 Enter the PIN code into the wireless
router from PC, etc.
•
“Linking” is displayed.
•
When the connection is established,
“Success” is displayed.
-
“Fail” may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If “Fail” is still
displayed, try other methods (
19).
3 Press [OK] on the remote control to
exit the setting.
•
“
” is displayed.
Note
•
Depending on a router, other connected
devices may temporarily lose their connection.
•
For details, refer to the operating instructions of
the wireless router.
(21)