TEC B-450 SERIES, User Manual

Page: 170 / 222

6-20
EO18-33003A 6. DIAG. TEST OPERATION
NOTES: 1. Holding the [
↓
] key or [
↑
] key down for more than 0.5 seconds enables a fast forward.
2. Max. fine adjustment
±
99.5 mm = X axis value
When the value reaches the maximum, the value remains unchanged even if the
subsequent fine adjustment is performed.
3. A changed X axis is stored in keyboard memory by pressing the [
→
] key.
■
[
↓
] key: Pressing the [
↓
] key one time
is a -0.5 mm change, up to -
99.5 mm. (See NOTE 2.)
■
[
↑
] key: Pressing the [
↑
] key one time
is a +0.5 mm change, up to
+99.5 mm. (See NOTE 2.)
6.3 PARAMETER SETTING MODE
6.3.4 X Axis Fine Adjustment
Power off
< 1
D I A G .
>
< 2
P A R A M E T E R S E T
>
X
D J U S T + 0 . 0 m m
A
S E T O P R I N ? T T E R
Y E
: [ E N T ] N C ]
S O : [
Press the [ENTER] key or [C] key.
Press the [C] key.
Turn on the power while
holding down the [SHIFT]
key.
Press the [
↓
] key.
Press the [
→
] key four times.
Press the [
↓
] or
[
↑
] key to fine
adjust the print position
along the X axis.
(See NOTE 1.)
Press the [ENTER] key.
Press the [
→
] key.
Continued on Section 6.3.5
Print tone fine adjustment
(Thermal Transfer).