TEC B-450 SERIES, User Manual

Page: 188 / 222

6-38
EO18-33003A 6. DIAG. TEST OPERATION
6.4 TEST PRINT MODE
6.4 TEST PRINT MODE (When using the KB-80-QM Optional Keyboard)
Eight kinds of test prints are provided in the test print mode. When performing the test print, 7
parameters should be set. The default parameter at power on is as below:
•
ISSUE COUNT : 1
•
PRINT SPEED : 2 inch/sec.
•
SENSOR : Transmissive sensor (Feed gap sensor)
•
TYPE : Batch (without cut)
•
LABEL LENGTH : 76 mm
•
LABEL WIDTH : 104 mm
•
PAPER FEED : Feed
Operating procedure for the test mode is provided below.
Power off
Turn on the power while
holding down the [SHIFT]
key.
Press the [
↓
] key twice.
Press the [
→
] key.
Press the [C] key.
Set the print count
Select "Print Condition"
by pressing the
[
→
] key.
Press the [
↓
] key.
(See NOTE 1.)
ISSUE COUNT
< 1
D I A G .
>
< 3
T E S T P R I N T
>
P R N T C O N D I T I O N I
From (C) on
the next page.
To be continued on
(B) of the next page.
To be continued
on (A) of the 6-41
page.
PRINT SPEED
SENSOR
TYPE
LABEL LENGTH
LABEL WIDTH
PAPER FEED
I S U E C O U N T 1 S