TEC B-450 SERIES, User Manual

Page: 84 / 222

2-3
2. SUPPLY SPECIFICATIONS
EO10-33003A
[HS model]
NOTES: 1. The thickness of the backing paper should be 56
µ
m or more.
2. The label should be at least three times as long as the detection gap.
3. The max. paper width includes the backing paper width.
4. Use Glassine paper 7K, 8K, or equivalent type for the backing paper. (Transparency rate
should exceed 22%.)
5. Relations between media roll length and core diameter.The unit of measure should be
unified.
L: Paper length d: Paper core outside diameter
D: Max. roll diameter t: Paper thickness
6. When using the cutter, be sure to cut the gap between labels. Perforated labels should be
tested before use.
7. When cutting the label, secure a gap of 6 mm or more and cut in the middle of the gap.
8. Fanfold paper cannot be used.
9. How to fix the label stock to the paper core
Remove the labels from the backing paper for the minimum of 400 mm long and fix the
backing paper edge to the paper core as shown below. Failure to do this may cause a void
print because the powder on the paper core surface may be attached to the label which
contacts with the paper core.
L =
4t
(D -d ) x
π
2 2
2.1 PAPER
Type
Item
Width (mm)
Pitch (mm)
Length (mm)
Thickness (mm)
Shape
Outer roll diameter
Paper core (mm)
Recommended paper
Label
On-demand
25.4 - 110.0
25.4 - 999.0
23.4 - 997.0
0.13 - 0.17
Roll paper wound inside.
152.4 mm max.
Inner diameter ø38, 40, 42, 76.2
±
0.3
LINTEC: FR1510-50 SILVER PET
LINTEC: FR1412-50 WHITE PET
Batch
7.0 - 999.0
5.0 - 997.0
0.10 - 0.17
Auto-cut
37.0 - 999.0
31.0 - 993.0
0.10 - 0.17
Fig. 2-7
Paper Core
Adhesive Tape
Backing Paper
Min. 400 mm
Label