TEC B-450 SERIES, User Manual

Page: 180 / 222

6-30
EO18-33003A 6. DIAG. TEST OPERATION
6.3.13 Strip Wait Status Setting
NOTES: 1. When the status type 1 is selected, the printer will send (00H) in response to the
status request command sent from the PC while a label stays at the strip sensor
(when idling, after feeding, or all printing finished).
When the status type 2 is selected, the printer will send (05H) in response to the
status request command sent from the PC while a label stays at the strip sensor
(when idling, after feeding, or all printing finished.)
If the status request command is sent during printing, the printer will always send
(05H) regardless of the setting.
2. A changed strip wait status is stored in keyboard memory by pressing the [
→
] key.
■
[
↓
] key:
Status type 2: A strip wait status is sent.
■
[
↑
]key:
Status type 1: A strip wait status is not sent.
Power off
Turn on the power while
holding down the [SHIFT]
key.
Press the [
↓
] key.
Press the [
→
] key thirteen times.
< 1
D I A G .
>
< 2
P A R A M E T E R S E T
>
1
S T T U S T Y P E A
Press the [
↓
] key or
[
↑
] key to select the strip
wait status.
Press the [ENTER] key.
Press the [
→
] key.
Continued on Section 6.3.14
Threshold Manual Fine
Adjustment for the Black
Mark Sensor.
S E T O P R I N ? T T E R
Y E
: [ E N T ] N C ]
S
O : [
Press the [ENTER] key or [C] key.
Press the [C] key.
6.3 PARAMETER SETTING MODE