13
www.TEC-electronics.ru
TEC-63062-1 AutoCAN-Fv6
PIN-code
A PIN-code is a confidential combination of presses on one or several original buttons of the
vehicle. The PIN-code represents a 1-, 2-, 3- or 4-digit number. The PIN-code is used when the
functions ‘Increased Security’ and ‘Impulse When Entering PIN-code’are active. For the list of original
buttons which can be «seen» by the controller in each specific vehicle, see Integrator. The PIN-code
represents a 1-, 2-, 3- or 4-digit number. An individual PIN-code is assigned by the installer when
installing the controller.
PIN-code Entry
The PIN-code is entered with the ignition turned on or with the engine started by pressing the
original buttons evenly; take care that when setting one of the digits the duration of presses and
pauses between them does not exceed 1 second. Make a pause of about 2 seconds between the
digits. In case you have made and error when entering the PIN-code, after about 3 seconds an
audible signal is heard meaning that the PIN-code shall be entered again.
PIN-Code Examples
The buttons
,
,
,
,
are used as an example.
For the list of available buttons, refer to the installer.
PIN-code entry with single button
One-digit PIN-code:
One-digit PIN-code:
pause 2 seconds
PIN-code entry using several buttons
When entering the PIN-code, you must monitor the button sequence.
One-digit PIN-code:
Two-digit PIN-code:
pause 2 seconds
PIN-code Change
1. Turn the ignition on.
2. Enter the current PIN-code. The built-in LED will blink once and a single impulse will be formed
in the ‘Impulse when entering PIN-code’ output.
3. Press any button used for entering the PIN-code 14 times. If you are changing the factory PIN-
code, press the built-in button 14 times. Wait for confirmation: single blinking of the built-in LED and
impulse in the ‘Impulse when entering PIN-code’ output.