4
www.TEC-electronics.ru
TEC-63062-1 AutoCAN-Fv6
Forced Interfacing
Enables forced assignment of the group and subgroup, to be used only in exceptional cases.
Programming Sequence:
1. Supply power to the controller and wait for intermittent light signals.
2. Press and release the built-in button 10 times. If all the actions are correct, the controller will
inform about this with three light signals.
3. Press the built-in button once. The controller informs about option selection with repeated single
light signals.
4. Enter the group number by pressing the built-in button for the corresponding number of times.
The controller will periodically emit series of light signals, where the number of signals corresponds
to the group number.
If a group represents a two-digit number, enter the first digit of the group number, wait for
2 seconds, and enter the second digit of the group number.
The controller will periodically give series of audible signals corresponding to the group
number.
5. Wait for 2 seconds.
6. Enter the subgroup number by pressing the built-in button the corresponding number of times.
Check correctness of the group and subgroup assignment by checking light signals (group
number – pause, subgroup number – pause):
• if the group and subgroup iscorrect, press the built-in button once.
• if the group and subgroup is not correct, press the built-in button two times.
Repeat the programming sequence starting from item #4.
Programming of Analogue Steering Wheel Buttons
In order to use the analogue steering wheel buttons:
•
Immediately after the controller has identified the vehicle model, turn the ignition on and
wait for at least 5 seconds.
• Sequentially (one after another) press all the steering wheel buttons and steering column
joysticks (cruise control, main unit control, etc.). The buttons, upon pressing which the
controller emits a lightsignal, will be available for use.
•
Turn the ignition off. Wait for confirmation: single flashing of the built-in LED.
The analogue steering wheel buttons programming shall be started within 15 minutes from the
moment the controller has been interfaced to the vehicle. If more than 15 minutes has passed,
reset to the factory settings and program the controller again.
