10
www.TEC-electronics.ru
TEC-63062-1 AutoCAN-Fv6
Table 4. Programmable Input Functions
№
Function
Description
1
Activate Control Lock + Comfort
(command)
Comfort is always enabled when the signal in the input lasts for more than 2
seconds and stopped when the control signal is removed from the controller
input. The function operation does not depend on Automatic windows closing
option setting.
2
Deactivate central lock
(command)
Sending an impulse to this input allows deactivating the central lock.
3
Open trunk (command)
Sending an impulse to this input allows opening the trunk lid
4
Turn lights activation
Sending an impulse to this input allows blinking with turn lights. In some
vehicles, due to their design peculiarities, uneven lamp blinking may be
observed while the impulses are fed evenly.
5
Horn control
Excitation signal to this input enables function No. 11 - Panic on horn from
external input. Halting the input excitation stops this function.
6
Start the engine
Engine is started via the CAN bus.
7
Central lock activated (status)
This function is used in exceptional cases when central lock status is not
available in the CAN bus (see Integrator).
8
Central lock deactivated (status)
This function is used in exceptional cases when central lock status is not
available in the CAN bus (see Integrator).
9
PDC control button
This function is used for managing the Parking Distance Control function with
an external button.
10
Hood control
The function is used when information about the hood position is not available
in the vehicle CAN bus. In this case, the Hood control input shall be connected
to the hood limit switch.
11 Comfort halting
Sending an impulse to this input enables stopping the controller automatic
windows closing function (comfort) and hence ventilating the vehicle. Sending
an impulse prior to setting the vehicle in the Security mode cancels the launch
of Comfort feature for this setting.
12 Brakelights condition control
The function is used when information about the brake pedal position is not
available in the vehicle CAN bus. In this case, the brakelights condition control
input shall be connected to the output of the brake pedal limit switch.
13 Driver’s door opening simulation
Sending an impulse to this input enables simulation of the driver’s door
opening via the CAN-bus. The function can be used for ACC signal disabling
after remote starting.
Programming Sequence
1. Turn the ignition on.
2. For entering Menu 1, press the built-in button 10 times; the controller will give three light signals.
For entering Menu 2, press the built-in button 12 times, the controller will give four light signals.
3. Select the required option according to Table 1 or 2 by pressing and releasing the built-in button
such number of times which corresponds to the required option number. The controller shall inform
about the option number with series of light signals.
