12
TEC-67398-2
Technical description Prizrak-5S BT
Immobilizer
adjustments
1st step. Interfacing the immobilizer with a vehicle
All vehicles compatible with the immobilizer system are devided into functional groups. Each group is devided
into subgroup. Groups and subgroups are endowed with a special number (https://int.tecel.ru/). Interfacing the
immobilizer with a vehicle means vehicle group and subgroup identification.
The interfacing procedure may be carried out as follows:
•
via a laptop or a PC.
•
automatically – by connecting the immobilizer to a vehicle’s harness.
•
manually – by using the programming menu of the immobilizer.
Interfacing via a PC
A vehicle make, model and other settings of the Immobilizer system can be configured using a PC with the al
-
ready installed software TECprog2. This intefacing method helps shorten the installation time and avoid possible
mistakes in programming.
Automatic interfacing
The immobilizer identifies an appropriate group and subgroup after connecting it to the vehicle's CAN-bus and
power source, and performing some simple actions (the typical simple actions are: cycling the ignition on/off and
locking/unlock ing a vehicle using the original remote). An interfacing procedure for each vehicle make and model is
described in the Integrator (https://int.tecel.ru). After carrying out all necessary actions you have to make sure that
the group and subgroup have been identified correctly. The identified group and subgroup is indicated by beeps (a
group number - pause, a subgroup number-pause).
If a vehicle group is a two-digit number – then every figure will be indicated separately. For example, the group
35 and the subgroup 2 will be indicated as follows: 3 long beeps – 1 sec pause, 5 long beeps – 2 sec. pause, 2
short beeps – 4 sec. The module will indicate the detected group and subgroup circularly 3 times.
Manual interfacing
This interfacing method might be necessary only in exceptional cases. A group and subgroup programming is
carried out with the built-in programming (reset) button. Make sure no group and subgroup is already programmed
before you start the procedure, the CAN-bus must not be connected as well. If within 60 seconds the programming
button is not pressed the module will automatically abort the programming process.
Manual interfacing is carried out as follows:
1.
Power up the immobilizer, wait until it starts emitting intermittent beeps.
2.
Not later than in ten seconds after that press the programming button 10 times to enter the «Menu 10».
The module will emit 3 beeps to confirm that the appropriate programming menu has been successfully
selected.
3.
Press the programming button 1 time in order to enter the option №1 «Vehicle model». The immobilizer will
indicate the selected option number by a repeating series of 1 beep.
4.
Press and release the programming button the number of times that corresponds to a group number you
wish to program (refer to the Integrator).
5.
Then enter a subgroup number by pressing and releasing the programming button the appropriate number
of times (refer to the integrator).
•
In case if a vehicle group consists of a two-digit number, enter the first didgit of the group number, wait
for two seconds and then enter the second digit of the group number. The immobilizer will emit a series of
beeps which corresponds to a group number.
Make sure you have programmed the correct vehicle model by listening to the emitted beeps:
•
press and release the programming button 1 time if everything is correct, The immoblizer will stop beeping
the vehicle model is now programmed.
•
press and release the programming button 2 times if there is a mistake. Repeat the programming process
from the step №4.
